Processing information for AR 300-80 (new)
AR 300-80 new is applied by spin coating between 1000 and 6000 rpm. The film thickness can be adjusted by varying the spin speed to the optimum conditions of the respective process.
Higher spin speeds and thus thinner films are preferable, e.g. 4000 rpm with approx. 15 nm thickness. Too high concentrations (film thickness values) may reduce or neutralize the adhesion-promoting effect.
It is recommended for AR 300-80 new to perform the subsequent tempering on a hot plate for 2 min or in a convection oven for 25 min at 180 °C. AR 300-80 new offers the big advantage for sensitive substrates that a bake step at only 60 °C for the same amount of time is sufficient, even though higher temperatures are well tolerated. The previous AR 300-80 product will only be sold as long as it is in stock.
During tempering, a very uniform, extremely thin layer of adhesion promoter is generated on the substrate (approx. 15 nm). After cooling of the substrate, the resist can be applied as usual.
An excess of adhesion promoter may be rinsed off with organic solvents like e.g. AR 600-70 or AR 600-71. The optimized surface properties are maintained without restriction.
AR 300-80使用方法是以轉速介於1,000rpm到6,000rpm的旋轉塗布法. 膜厚可依轉速而調整. 較高的轉速可得較低的膜厚. 例如每分鐘4,000轉可得約15nm的膜厚. 膜厚太高可能影響增黏效果.
AR 300-80塗布後,建議軟考時間為2分鐘(熱板),或180℃烤箱25分鐘. 針對有些較敏感的基板, 其烘烤溫度僅能為60℃, AR 300-80在此製程條件下依然可達增黏效果. AR 300-80對溫度有較寬的製程容忍度.
經過烘烤後AR 300-80會在基板表面形成厚度一致,約15nm的薄膜. 基板經降溫冷卻後就可依製程進行阻劑塗布. 過厚的增黏劑可以AR 600-70或AR 600-71清洗. 清洗後的表面仍可維持其增黏特性.
